Bending the upshift lever return spring. To keep the upshift spring from popping out of place during reassembly, I had to bend both tabs quite drastically using needlenose pliers. This photograph shows the final angle of the upper tab. The tab is on the side closest to the camera, so that it is twisted towards the wire from whence it leads.

Bending the upshift lever return spring.  To keep the upshift spring
from popping out of place during reassembly, I had to bend both tabs
quite drastically using needlenose pliers.  This photograph shows the
final angle of the upper tab.  The tab is on the side closest to the
camera, so that it is twisted towards the wire from whence it leads.